型号：SW7100*防眩泛光工作灯【出售】 返回列表页

SW7100*防眩泛光工作灯:
SW7100 full range of glareproof floodlight working lamp:
型号：SW7100*防眩泛光工作灯【出售】适用范围：
Scope of application:
适用于各类厂区、车间、场站和大型设施、场馆等场所作泛光照明。
Suitable for lighting in various types of plant, plant, station and large facilities, venues and other places.
各种配电室、主厂房、水泵房、锅炉房、廊道、栈桥、煤仓内等场所固定工作照明。
All kinds of power distribution room, main building, water pump room, boiler room, corridor, Zhanqiao, bunker and other places fixed lighting.

一、性能特点:
First, the performance characteristics:
采用高效、长寿气体放电光源(MH/HP气体放电灯)，寿命可高达28500小时;功率因数大于0.9，发光效率高，透光性好。
High efficiency, long life gas discharge light source (MH/HP gas discharge lamp), life can be as high as 28500 hours; power factor is greater than 0.9, high luminous efficiency, good light transmission.
运用先进的光学和照明原理优化设计透明件，光线柔和，照度均匀，无眩光，无重影，能有效避免作业、施工人员产生不适和疲劳感。
Use of advanced optical and lighting principles to optimize the design of transparent parts, soft light, uniform illumination, no glare, no heavy shadow, can effectively avoid the operation, construction workers produce discomfort and fatigue.
一体化和多重防振结构设计，确保其在高频、多频振动环境中长期*工作。
Integrated and multiple anti vibration structure design, to ensure that it is in a high frequency, multi frequency vibration environment for a long time without trouble.
选用高强度铝合金外壳，进行特殊的密封和表面涂层处理，可在高温潮湿和各种腐蚀性等恶劣条件下长期使用。
High strength aluminum alloy shell, special sealing and surface coating treatment, high temperature and humidity and a variety of corrosive and other harsh conditions for long-term use.
座式、吸顶式和吊顶式等多种安装方式，适应不同工作现场的照明需要。
Seat type, ceiling type and ceiling type, and other installation methods, to adapt to the needs of different working scene lighting.
二、使用方法:
Two, the use of methods:
确定灯具的安装位置，选择适当的安装方式，并按灯具到220V电源接点的距离，准备好相应长度的φ6~8mm三芯电缆线;
To determine the installation position of the lamp, select the appropriate installation mode, and to the 220V power supply contact distance according to the length of the corresponding lamps, ready for 6~8mm three core cable;
扳开灯座上的两个锁扣打开后盖，将准备好的三芯电缆线一端穿过引入口，将火线(L)接在“L”端子上，零线(N)接在“N”端子上，地线(PE)接在“PE”端子上，再将引入口的电缆线用压紧螺母压紧后，合上后盖，扣紧锁扣，zui后将三芯电缆线另一端接通电源，即可实现照明。
Two open the socket lock to open the cover, the three core cable will be ready to end through the inlet, the FireWire (L) connected to the "L" terminal, the zero line (N) connected to the N terminal on the ground (PE) connected to the PE terminal, then the introduction of cable in the nut is tightened, close the rear lid lock buckle, buckle, the three core cable the other end is connected with the power supply, lighting can be realized.
更换灯泡时，按使用方法2打开后盖，将灯座右旋，并从灯盖上轻轻拔出，旋下灯座上的旧灯泡，换上新灯泡即可。
When replacing the bulb, by using the method of 2 will open the back cover, the lamp holder and the lamp cover from the right, gently pull out, unscrew the lamp on the old bulbs replaced the new bulbs.
安装：
Installation:
吊顶安装：先用4个M8螺栓将吊装转接板固定在灯具上，将三芯电缆线穿过G3/4管螺纹口，穿过侧面的圆孔和灯座一侧的引入口，连接到灯具上，然后将灯具的G3/4管螺纹和带有标准G3/4管螺纹的布线钢管拧在一起。
Ceiling installation: first with the 4 M8 bolts lifting adapter plate is fixed on a lamp, three core cable through G3/4 pipe thread, introduced through the side hole and the side of the mouth is connected to the lamp holder, lamp, and lamp with standard G3/4 and G3/4 pipe thread pipe thread steel pipe wiring together.
吸顶安装：根据灯具的安装孔位尺寸，在灯具要安装的位置上打相应的安装螺栓孔，用M8螺栓安装固定。
Ceiling installation: according to the installation hole position of lamps and lanterns, the corresponding installation bolt hole should be installed at the position of the lamp to be installed, and fixed with M8 bolt.
多灯并联。
Multi lamp parallel connection.
三、型号：SW7100*防眩泛光工作灯【出售】注意事项:
Three, matters needing attention:
运输时将灯具装在所配备的纸箱内，并加装泡沫减震。
When transporting, the lamp is arranged in the box, and the foam damping is added.
使用时，灯具表面有一定的温升，属正常现象;透明件中心温度较高，不得触摸。
When in use, the lamp surface has a certain temperature rise, which is a normal phenomenon; the central temperature of the transparent piece is higher, and the temperature of the lamp can not be touched.
更换灯泡时，应使用同类型、功率的灯泡;如果改变灯泡类型或功率，应相应更换配套镇流器。
When changing a bulb, the bulb of the same type and the power should be used; if the type or power of the bulb is changed, the corresponding ballast should be replaced accordingly.
四、技术参数:
Four, technical parameters:
额定电压:220VAC50Hz
Rated voltage: 220VAC50Hz
额定功率:70/100/150W
Rated power: 70/100/150W
外壳防护等级:IP65
Shell protection class: IP65
进线口螺纹:G3/4
Thread of thread: G3/4
引入电缆:φ6~φ8mm
Introduction: Phi 6~ Phi 8mm cable
外形尺寸:226×220×300mm
Outline dimension: 226 * 220 * 300mm
总重量:6Kg
Total weight: 6Kg
五、*:
Five, quality assurance:
本产品严格按照ISO9001:2000质量管理体系标准进行质量控制,确保产品质量高于国家标准,*达到设计要求,产品实行3年保用,光源保用一年,自购买之日起3年内，产品正常使用下出现任何故障由本公司负责免费维护
This product is in strict accordance with the ISO9001:2000 international quality management system standards for quality control, ensure product quality is higher than the national standard, fully meet the design requirements, products 3 years warranty, the light source is guaranteed for one year, 3 years from the date of purchase, the product under normal use of any failure by the company responsible for free maintenance