通信电缆 网络设备 无线通信 云计算|大数据 显示设备 存储设备 网络辅助设备 信号传输处理 多媒体设备 广播系统 智慧城市管理系统 其它智慧基建产品
深圳市连讯达电子技术开发有限公司
深圳市连讯达电子技术开发有限公司
梅凯Megger DET4T2系列DET4TD2|DET4TR2|DET4TC2|DET4TCR2绝缘电阻测试仪
梅凯Megger MIT300|MIT310|MIT310A|MIT320| MIT330绝缘电阻测试仪
梅凯Megger MIT400/2|MIT410/2|MIT420/2 |MIT430/2 四类绝缘测试仪
梅凯Megger MIT481/2 和 MIT485/2绝缘电阻测试仪
梅凯Megger MIT2500高压手持式绝缘和连续性测试仪
梅凯Megger DLRO100E,DLRO100X及DLRO100H高度便携微欧表100A
梅凯Megger MIT415/2 和 MIT417/2绝缘电阻测试仪
梅凯Megger MIT200|MIT210|MIT220|MIT230绝缘电阻测试仪
梅凯Megger MOM600A，MOM200A微欧计（回路电阻计）
梅凯Megger DET2/3高分辨率接地测试仪DET2/3RC
梅凯Megger DLRO10HDX低电阻微欧计DLRO10HD
梅凯Megger DET14C 和 DET24C接地电阻测试仪
梅凯Megger S1-1568直流绝缘电阻测试仪 15 kV
梅凯Megger S1-1068直流绝缘电阻测试仪S11068
EXFO光功率计PX1,PX1-PRO,PX1-S-PRO,PX1-H-PRO,PX1-S-PRO,PX1-H-PRO
EXFO FPM-600光功率计FPM-602 FPM-602X
EXFO FTBx-720C LAN/WAN接入网OTDR光时域反射仪
EXFO FTBx-730C PON FTTx/MDU OTDR光时域测试仪
EXFO FTBx-735C城域网/PON FTTx/MDU OTDR
EXFO MaxTester 720C - 接入网OTDR光时域反射仪
EXFO MaxTester 730C PON/城域网OTDR光时域反射仪
EXFO ELS-50光源ELS-50-23BL单模ELS-50-12C多模光源
EXFO FPM-300光功率计FPM-302，FPM-302X
EXFO FLS-300单多模光源FLS-300-12D,FLS-300-235BL
NetAlly TEST-ACC吞吐测试选件(iPerf服务器)TEST-ACC-5PK/TEST-ACC-10PK
NetAlly Aircheck G2无线网络测试仪AIRCHECKG2-TA-KT
NetAlly LinkRunner 10G网络测试仪LR10G-100|LR10G-100-KIT|EXG-LR10G-KIT
NetAlly LRAT-2000/LRAT-1000网络测试仪LinkRunner AT(LRAT-2000-KIT)
NetAlly LinkRunner G2智能网络测试仪LR-G2,LR-G2-KIT,LR-G2-ACKG2-CBO
NetAlly AirMagnet Wi-Fi Analyzer PRO无线分析仪(AM/A1150)
NetAlly EXG-200|EXG-200-KIT网络测试仪EtherScope nXG
NetAlly LSPRNTR-300网络测试仪LinkSprinter
NetAlly AirMagnet Survey PRO无线勘测仪WLAN分析工具(AM/A4018)
NetAlly AirMagnet Spectrum XT频谱分析仪(AM/B4070|AM/A4040)
NetAlly 1TG2-3000/1TG2-1500网络性能测试仪1T10G-1000
NetAlly EXG-200-KIT|EXG-200-KIT-2PK|EXG-200-LRG2-KIT|EXG-LR10G-KIT网络测试仪EtherScope nXG
NetAlly AirCheck G3 Pro 第三代无线网络测试分析仪
NETSCOUT 1TG2-3000-2PAK|1TG2-1500-2PAK|1T10G-1000-2PAK|网络测试助手Onetouch AT G2
NETSCOUT LRAT-1000|LRAT-2000网络测试仪LinkRunner AT
NETSCOUT AirMagnet Survey无线测试仪
NETSCOUT AirMagnet Spectrum XT无线频谱分析仪
NETSCOUT LSPRNTR-300 网络测试仪LinkSprinter
NETSCOUT AirMagnet WiFi Analyzer PRO无线网络测试仪
NetAlly(NetScout) 1TG2-1500-LRAT2/1TG2-3000-LRAT2网络测试仪
NETSCOUT 1TG2-1500|1TG2-3000|1T10G-1000网络测试仪
NETSCOUT LR-G2|LR-G2-KIT智能网络测试仪LinkRunner G2|LR-G2-LS-KIT报价 图片 参数
暂无信息 |
阅读：16发布时间：2024-12-27
Port or cabling short Autotest not available - CableIQ
You may receive the following message:
The Autotest may not run if the tester is connected to a data port, detects voltage or a short on the cabling. If any of these three instances occur, you may see the screen above.
Rotate the dial to DISCOVER. The CableIQ should be able to tell you why it cannot run an Autotest. In this example, the CableIQ was connected to an active port:
Here we see that the port the CableIQ is connected to is capable for 10BASE-T, 100BASE-T is Full Duplex mode and is 41.5 m from the CableIQ.
What if the warning "Port or Cabling short Autotest not available" occurs while connecting the Cable IQ over a cable to the CIQ-WM far end adapter?
This is an indication that the far end adapter may need to be replaced.
You can validate the RJ45 port on the Cable IQ by leaving the cable attached and turn the dial to DISCOVER. If the RJ45 port is good, you should be able to press F1 and see the pair lengths on the attached cable. It is normal to see a small variance on pair lengths between the pairs, as the twist rates are different. If you see 0 length for a pair, it indicates a problem with the RJ45 port on the Cable IQ; contact the Service Center for repair.
If you have any of the additional office identifiers for Cable IQ (CIQ-IDK24 or CIQ-IDK57), try using one at the far end of the cable with an RJ45 coupling and see it it works to run the Autotest.
Otherwise, replace your CIQ-WM far end adapter.
智慧城市网 设计制作，未经允许翻录必究 .
请输入账号
请输入密码
请输验证码