频率 频率范围 150kHz ~ 1GHz 频率解析度 1kHz C.F. entry, 40Hz Sweep resolution at 2kHz/DIV 频率显示 6 1/2 digit setting 频率控制 Digital phase locked 频率稳定度 +2ppm/year aging, +10ppm, 0 to 50°C 频率频距 (Spans) Zero, 2kHz to 100MHz/div, in a 1-2-5 sequence 频宽 解析频宽 3kHz, 30kHz, 220kHz, 4MHz 解析频宽准确度 15% 视频频宽 1.6kHz/90kHz coupled with RBW 振幅 参考准位范围 -30dBm 到+20dBm 参考准位准确度 +1dB at 80MHz 输入准位范围 -100dBm 到 +20dBm 杂讯准位 -95dBm@30kHz RBW, -100dBm typical/-75dBm:150kHz ~ 10MHz 振幅显示范围 75dB 振幅准确度 + 1.5dB typical@0dBm, 80MHz 振幅准位线性 + 1.5dB over 70dB 参考准位频率平坦度 +1.5dB over 100MHz, +2.5dB typical over entire band/+3dB:150kHz ~10MHz 谐波突波响应 <-40dBc, RF input < selected reference 非谐波突波响应 <-60dBc typical down from reference level, average, 5MHz/div 三阶交互调变杂讯 (3rd) <-70dBc, @-40dBm input, 2 tones, 2MHz part/<-45dBc:150kHz ~10MHz 相位杂讯 -77dBc/Hz at 1GHz, 30kHz offset 输入 输入过载保护 +30dBm continuous, +25VDC 阻抗 50 ohm nominal 回复损失 <16 dB (VSWR < 1.35) 输入衰减 50dB to 0dB in 10 dB steps coupled to reference level 连接头 Type N female 游标 游标数 2 游标解析度 0.1dB, 1kHz 游标模式 值, 相对值, PK->Marker, Marker->Center 游标准确度 0.1dB+振幅准确度 其他功能 记忆 9 组参数设定记忆组 Trace Max. Hold, Average (2 ~ 32 traces), Freeze(Hold) 设定 Access parameters FM/AM DEMODULATOR WB FM 120kHz deviation MB FM 75kHz deviation NB FM 30kHz deviation AM Outputs Internal speaker, 3.5mm stereo jack, wired for mono operation
GSP-810 1GHz Spectrum Analyzer
| Opt. 01 | Tracking Generator | · Frequency range: 150kHz ~ 1GHz · Amplitude range: -50 ~ 0dBm · Amplitude resolution: 1dB · Amplitude accuracy: ±1dB @ 0dBm, 80MHz · Attenuation accuracy: ±1dB @ 50MHz · Amplitude flatness: ±1dB @10MHz/div, 1.5dB @0dB, entire band · Harmonics: < -30dBc (<-25dBc, 150kHz ~ 10MHz) · Reverse power: < +30dBm · Impedance: 50 ohm nominal · Return loss: < 10dB (VSWR < 2) · Connector: Type N female | |
| Opt. 02 | Power Meter | · Frequency Range: 10MHz ~ 2 GHz, usable to 2.7GHz · Power Level Range: -20 dBm ~ +23 dBm, usable to +30 dBm · Power Level Overload: +40 dBm < 10% duty cycle, < 10 mS duration · Return Loss: < 1:1.35 VSWR into 50 ohms, < 1:1.25 typical · Readout Resolution: 0.2 mW, 100 mW scale, 2 W, 1 mW scale; 0.1dB, Log scale · Accuracy: ±(10% rdg 1digit) · Readout: mW or dBm | |
| Opt. 03 | Remote Control Software | · Connecting PC to get the trace and provide the control for setting | |
| OPTIONAL ACCESSORIES | |||
| ATA-001 | BNC Antenna (An additional ADP-001 is needed for fitting GSP spectrum analyzers) | ||
| ATA-002 | Near Field Probe (An additional ADP-001 & GTL-110 is needed for fitting GSP spectrum analyzers) | ||
| RLB-001 | Return Loss Bridge RLB Frequency Range 10MHz ~ 1GHz | ||
| GTP-3000 | Passive touch Probe Set PR-03: Passive touch probe, SMA(F) ADP-002: Adaptor, SMA(J/F) ~ N(P/M) GTL-303: RF Cable Assembly, SMA(P/M), 600mm | ||
| GKT-001 | General Kit set ADP-002: adaptor, SMA(J/F) ~ N(P/M) x 2 ATN-100: 10dB attenuator, N(J/F) ~ N(P/M) x 1 GTL-303: RF cable assembly(SMA(P/M),RD316,600mm)x2 GSC-002: Kit box x 1 | ||
| GKT-002 | CATV Kit set ADP-001: adaptor, BNC(J/F) ~ N(P/M) x 2 ADP-101: adaptor, BNC(J/F)75Ω ~ BNC(P/M)50Ωx 2 GTL-304: RF cable assembly(RG223,N(P/M)-N(J/F),300mm)x2 GSC-003: Kit box x 1 | ||
| GKT-003 | RLB Kit set GAK-001: termination 50 , N(P/M) x 1 GAK-002: Cap with chain, N(P/M) x 1 GTL-302: RF cable assembly(RG223,N(P/M),300mm)x2 GSC-004: Kit box x 1 | ||
| GKT-006 | EMI Probe Kit set ANT-01: 6cm Loop, H-Field Probe x 1 ANT-02: 3cm Loop, H-Field Probe x 1 ANT-03 6mm Stub tip, E- Field Probe x 1 PR-03: Touch Passive Probe x 1 ADP-02: N(P/M)~SMA(J/F) Adapter x 1 ADP-01: N(P/M)~BNC(J/F) Adapter x 1 Test Lead: BNC(P/M)~BNC(P/M) RF Cable x 1 Test Lead: SMA(P/M)~SMA(P/M) RF Cable x 1 | ||
| GTL-301 | RF Cable RG 223 N(P/M), 1000mm | ||
